Craftsman 113.206891 Owner's Manual page 15

e. Insert a pencil in space at end of cutterhead to
hold cutterguard open.
f. Wrap a piece of cardboard around cutterhead to
protect your fingers and the blades.., secure
cardboard with a piece of tape.
PENCI L
h. Loosen four lock screws 2 or'3 turns with 1/2 in.
wrench.
VIEW LOOKING UP FOR PARTS IDENTIFICATION
Turning the LEVELING STUDS will RAISE or LOWER
the infeed table.
SCREWING in the studs will RAISE the table...
UNSCREWING them will LOWER the table.
a. With a 3/4 in. wrench turn levering studs until
infeed table is parallel with straightedge.
b. While holding studs with wrench, TIGHTEN all
four LOCKSCREWS. ,. tighten each screw a little
bit at a time until all four screws are tight.
c. Recheck with straightedge to make sure infeed
table (in raised and lowered positions) is parallel
to outfeed table.
15