Auxiliary Fence - Craftsman 113.206891 Owner's Manual

b.
Co
d.
Loosen 90 ° stop screw with small screwdriver
and turn knurled sleeve which will cause fence to
tilt. Turn sleeve in either ,direction until fence is
square with infeed table,
NOTE: If you cannot square fence by turning
knurled sleeve, loosen three screws "A" and
adjust fence square to table.
Tighten 90° stop Iockscrew and both fence lock
knobs,
tf 90 ° reading on tilt scale does not line up with
top surface of the slide bracket, _ioosen screws
holding scale and move it... tighten screws.
45" STOP \
_J0_ STOP
/
SLIDE
BRACKET
SCALE
ADJUSTING
SCREW
'_45 _ STOP
LOCKSCREW
TILT
,,ISCALE
"gO ° STOP
LOCKSCRFW
SCALE
ADJUST! NG
SCREW
e. Adjust 45° stop in the same manner.
NOTE: Titt scale will not require adjustment if it
was adjusted for 90 ° position,
FENCE
HEAD
OF
SQUARE
\
CUTTER
GUARD
|NFEED
TABLE
] , ,,,, ,,,,,, i i !ll
AUXILIARY FENCE
Some on-edge and other jointing operations require a
higher and/or longer fence than your tool provides. Select
a piece of smooth straight wood of the height and length
required for proper support and bolt it to the tool fence as
shown for these operations.
1/4-20 FLAT HEAD J
SCREW _COUNTERSL
at
WARNING:
CUTTER GUARD. Provides protection over the
cutter head. It must always be in place and function-
ing properly.
Check the guard to make sure it is functioning
properly.
a. Posit_on fence to right for maximum width of cut.
b. Pass a 1/4 in. thick piece of wood over cutterhead
between guard and fence.
Guard must return automatically to "rest position"
against fence when free of the wood,
If guard does not return automatically, see Trouble
Shooting and Maintenance Sections.
CUTTER
GUARD
FENCE
13