Mounting Switch; Installing Motor, Pulley, V-Belt And Belt Guards - Craftsman 113.206891 Owner's Manual

MOUNTING SW|TCH
1. Locate the following parts:
! On/Off Power Outlet
2 Pan Hd. Screws, 1/4-20 x 1/2
IIj!' ILLLjl II JI!l II I
INSTALLING MOTOR, PULLEY, V-BELT AND BELT
GUARDS
1. Locate the following parts:
Qty. Description
1 Motor
1 "L" Bracket
2 Lockwashers, External 1/4
2 Washers, 17/64 x 1/2 x 1/32
2. Attach On/Off outlet to infeed table using two tapped
holes.
! Pulley (Approx. 2-1/2" Dia.)
1 V-Belt 1/2x52
CARRIAGE BOLT
5/16-18 x 3/4
4 Carriage Bolt 5/16-18 x 3/4
4 Flat Washer5/16 I.D.
4 Lockwasher 5/16 I.D.
4 Hex Nut 5/16-18
1 Guard Assembly including a guard support,
guard support bracket, self-threading screws,
and clips,
2, Place motor against the motor mounting bracket and
insert bolts through holes in motor base and then
through holes marked "X" in motor mounting bracket.
DO NOT TIGHTEN BOLTS AT THIS TIME. The "L"
bracket which holds the guard support must be slid
between the motor base and the motor mounting
3. Slide long teg of"L" bracket between motor base and
motor mounting brackeL Then sandwich the short leg
of the"L" bracket between the guard support bracket
and the guard support and loosely fasten together
with self-threading screws as shown. _nstall clips onto
belt guard support with long end of clip facing you.
bracket so motor must be loosely assembled to bracket
at this time.
SUPPORT BRA(
///
BRACKET
TWO HOLES CLOSEST
TOGETHER
_CLIPS
t0-32 X 112 IN.
SELF-THREADING
SCREW
BELT GUARD_,_ I_
SUPPORT _'_t
2-1/2" MOTOR PULLEY
5/32 INCH
SETSCREW
WRENCH
TIGHTEN
SET SCREW
AGAINST FLAT
ON SHAFT
4. Install the 2-1/2" pulley onto the motor shaft and
tighten the set screw in the pulley hub against the flat
part of the motor shaft.
FLUSH
HERE WtTH
MOTOR SHAFT
9