Advertisement
MAINTENANCE
WARNING:
When servicing use only identical Craftsman replacement
pads. Use of any other parts may create a hazard or
cause product damage.
i
GENERAL
Only the parts shown on parts list, page 15, are intended to
be repaired or replaced by the customer. All other parts
represent an important part of the double insulation system
and should be serviced only by a qualified Sears service
technician.
Avoid using solvents when cleaning plastic pads. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean cloths
to remove did, carbon dust, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc. come in contact
with plastic pads. They contain chemicals that can
damage, weaken, or destroy plastic.
When electdc tools are used on fiberglass boats, sports cars,
wallboard, spackling compounds, or plaster, it has been found
that they are subject to accelerated
wear and possible
premature failure, as the fiberglass chips and grindings are
highly abrasive to bearings, brushes, commutators, etc.
Consequently it is not recommended that this tool be used
for extended work on any fiberglass material, wallboard,
spackling compounds, or plaster. During any use on these
materials, it is extremely important that the tool is cleaned
frequently by blowing with an air jet.
WARNING:
Always wear safety goggles, or safety glasses with side
shields dudng power tool operation or when blowing dust.
If operation is dusty, also wear a dust mask.
i
I
EXTENSION
CORDS
The use of any extension cord will cause some loss of power.
To keep the loss to a minimum and to prevent tool
overheating, use an extension cord that is heavy enough to
carry the current the tool will draw.
A wire gauge size (A.W.G.) of at least 16 is recommended
for an extension cord 100 feet or less in length. When working
outdoors, use an extension cord that is suitable for outdoor
use. The cord's jacket will be marked WA.
CAUTION:
' Keep extension cords away from any planing area and
position the cord so that it will not get caught on lumber,
I tools, etc., during planing operation.
WARNING:
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions. Therefore, no further lubrication
is required.
Page 10
Advertisement
