Motor Connections; Recommended Accessories - Craftsman 113.206891 Owner's Manual

] 2
CRAFTSMAN 6-1/8 INCH JOINTER-PLANER
MODELS 113.206801,113.206932 AND 113.206891
NOTE:
ANY ATTEMPT TO REPAIR THIS MOTOR
MAY CREATE A HAZARD UNLESS
REPAIR IS DONE BY QUALIFIED
SERVICE TECHNICIAN.
REPAIR SERVICE IS AVA|LABLE
AT YOUR NEAREST SEARS STORE.
FIGURE 6 -- MOTOR PARTS LIST
Key PaH
No. No.
1 60306
2 64088
3 64258
Description
Screw, 8-32 x 3/8, Thread
Cutting, Slotted, Serrated Hd
Cover, Terminal
Cord with Plug
MOTOR CONNECTIONS
WARN I NG: FOR YOUR OWN SAFETY, NEVER CONNECT
PLUG TO POWER SOURCE OUTLET UNTIL ALL
ASSEMBLY STEPS ARE COMPLETED.
1, Open motor connector box cover located on left end
of motor (viewed from rear of saw) using a flat blade
screwdriver.
2, Remove GREEN SCREW and lockwasher and insert
screw through round metal terminal on the end of the
GREEN wire of power cord with !ockwasher between
terminal and motor frame. (See illus.)
3, Reinsert GREEN SCREW in the threaded hole. Tighten
securely.
4, Insert te,rminat end of WHITE wire on spade terminal
marked T4 on the motor. Push terminal firmly until
seated.
5, Insert terminal end of BLACK wire on spade terminal
marked T1 on the motor, Push terminal firmly until
seated.
6. Close motor connector box being sure that power
cord is seated in the largest strain relief groove, and
tighten box cover screws,
i i i 'IIH I
TERMINAL
GREEN
INTERNAL
LOCKWASHER
GREEN WIRE
-TO GREEN SCREW
STRAIN RELIEF
WHITE WIRE TO
TERMINAL T4
RECOMMENDED ACCESSORIES
ITEM CAT. NO.
Steel Legs ................................ 9-22245
Floor Stand ............................... 9-22216
Cutter Blades .............................. 9-2293
Power Tool Know-how Handbooks
Radial Saw ............................... 9-2917
Table Saw ............................... 9-2918
Knife Setting Gauge ......................... 9-2647
Chip Collector ............................ 9-29977
The above recommended accessories are current and
were available at the time this manual was printed,
31