List Gb: Distribution Bus Module (P/N 513806) (8) Fuse/Circuit Breaker System Positions W/Lvd And (1) Tph Fuse Battery Disconnect Position - Emerson SAG581126000 System Application Manual

page of 123

/ 123
Contents
Table of Contents
Bookmarks

Table of Contents

System Application Guide

Spec. No. 581126000 (Model 700

List GB: Distribution Bus Module (P/N 513806)

(8) Fuse/Circuit Breaker System Positions w/LVD and (1) TPH Fuse Battery Disconnect Position

Features

♦ Single Voltage Distribution (+24V)

♦ 500A Maximum Capacity

♦ (8) Load Distribution Fuse / Circuit Breaker Mounting Positions (3 to 100A TPS/TLS-Type Fuses / 1 to

250A Bullet Nose Type Circuit Breakers), or accepts

(P/N

514432)".

♦ (1) Battery Disconnect Fuse Mounting Position (70 to 600A TPH-Type)

♦ Low Voltage Load Disconnect Contactor

Restrictions

Limit one bus arrangement of this type per Distribution Cabinet.

Must be installed in bus position A (row 1) of a 1-, 2-, 3-, or 4-bus row cabinet.

Unless otherwise specified fuses and/or circuit breakers are mounted from left to right, starting with the

highest capacity and working to the lowest capacity.

125A, 150A, and 200A circuit breakers occupy two mounting positions. 250A circuit breakers occupy three

mounting positions.

Caution: A circuit breaker or fuse with a rating greater than 150 amperes SHALL HAVE an empty

mounting position between it and any other overcurrent protective device.

Maximum size of wire to be connected to a single TPS/TLS-type fuseholder or Bullet Nose-type circuit

breaker position is 2 AWG.

Ordering Notes

1) Order circuit breakers as required per

2) Order load distribution fuses as required per

Also order one (1) P/N 117201 bullet nose-type fuseholder per fuse ordered.

3) Order battery disconnect fuse as required per

4) Order load lugs (two hole, 1/4" bolt clearance hole, 5/8" centers) as required for each distribution position

per Table

or 11.

5) Order battery lugs (two hole, 3/8 bolt clearance hole, 1" centers) as required for each distribution position

per Table 10.

6) Order lug hardware kit,

ground lugs for four (4) positions of a bullet nose-type distribution assembly.

1/4-20 THREADED HOLE,

16 PLACES (CUSTOMER

MUST SUPPLY LUG BOLTS

This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy

Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.

)

NVBA

Table

P /N

520332, as required. Kit provides all hardware required to connect load and

1/4-20 STUD, 16 PLACES

CUSTOMER MUST SUPPLY

ADDITIONAL HARDWARE)

LOAD RETURN

CONNECTIONS

GROUND

BUSBAR