Pager Setup - Pager Number And Pin; Table 23 Pager Dialing Results - Emerson Autochangeover Controllers AC8 User Manual

7.8.3

Pager Setup - Pager Number and PIN

The AC8 may be configured to dial numeric or alphanumeric pagers when an alarm is detected. You
may enter up to four pager numbers—all configured pagers will be dialed each time an alarm occurs.
For each configured pager, you must enter the pager number to be dialed and the pager's Personal
Identification Number (PIN).
See 8.1 - AC8 Specifications for supported pager settings.
The AC8 can send numeric or alphanumeric messages to supported pagers, as shown in the following
example:
Alphanumeric pager
message example
When an alarm is detected, the first pager number is dialed—up to three times, if needed. After a suc-
cessful page or three dialing attempts, the next pager number is dialed, again with three attempts as
needed, and so on for all configured pagers.
Table 23 Pager dialing results
Result of Page
Successful
Unsuccessful due to:
Busy signal / no answer /
no dial tone
General modem
communication problem
No communication with
modem
(internal hardware problem)
To configure a pager:
Log In and Choose Setup System
• From the Main Menu, use the arrows
Control, then press Enter
• Enter your password at the Login screen.
• From the System and Control Menu, use the arrows
Setup System, then press Enter .
Select a Pager to Configure
• From the Setup System Menu, shown at right, use the arrows
to choose Setup Modem&Pagers and press Enter .
• Use the arrows
Modem Menu, and press Enter .
• From the Select Pager Menu, choose the pager number you
want—for example, Pager Number 1—and press Enter .
LIEBERT TEST
DEVICE_1 ALARM
CONTACT CLOSED
2:07 PM 06/09/04
AC8 dials next configured pager.
AC8 generates message after all three redial attempts
have failed, dials next configured pager.
AC8 resets modem, generates message, redials pager
up to three more times.
AC8 generates messages, makes no further dialing
attempts.
to choose System and
(see 7.1 - Login for help)
to choose Setup Pagers from the Pagers &
53
Pager company time stamp
Action
Setup System Menu
to choose
> SETUP MODEM&PAGERS
Pagers & Modem Menu
> SETUP PAGERS
Select Pager Menu
> PAGER NUMBER 1
System and Control Options
Message Generated
—
Unsuccessful Page
(Event Log)
Modem Reset
(Event Log)
Modem Internal Fault
(Active Alarm Report,
Alarm History Log)
SETUP INPUTS
SETUP COMMON ALARM
SETUP SENSOR
=NEXT =SELECT
SETUP ZONES
SETUP OUTPUTS
SETUP SYSTEM INFO
SETUP OPERATION
SETUP I/O MATRIX
SETUP MODEM
=NEXT =SELECT
SELECT PAGER
PAGER NUMBER 2
=NEXT =SELECT
PAGER NUMBER 3
PAGER NUMBER 4