TP-Link TL-SL5428E User Manual page 134

24-port 10/100mbps + 4-port gigabit l2 managed switch
Hide thumbs Also See for TL-SL5428E:
Table of Contents

Advertisement

Port Voice VLAN Mode
A voice VLAN can operate in two modes: automatic mode and manual mode.
Automatic Mode: In this mode, the switch automatically add a port which receives voice packets to
voice VLAN and determine the priority of the packets through learning the source MAC of the
UNTAG packets sent from IP phone when it is powered on. The aging time of voice VLAN can be
configured on the switch. If the switch does not receive any voice packet on the ingress port within
the aging time, the switch will remove this port from voice VLAN. Voice ports are automatically
added into or removed from voice VLAN.
Manual Mode: You need to manually add the port of IP phone to voice VLAN, and then the switch
will assign ACL rules and configure the priority of the packets through learning the source MAC
address of packets and matching OUI address.
In practice, the port voice VLAN mode is configured according to the type of packets sent out from
voice device and the link type of the port. The following table shows the detailed information.
Port Voice VLAN
Voice
Mode
Stream Type
Automatic Mode
TAG
stream
UNTAG voice
stream
Manual Mode
TAG
stream
UNTAG voice
stream
5
00-D0-1E-00-00-00
6
00-E0-75-00-00-00
7
00-E0-BB-00-00-00
Table 9-1 OUI addresses on the switch
Link type of the port and processing mode
voice
ACCESS: Not supported.
TRUNK: Supported. The default VLAN of the port can not be
voice VLAN.
GENERAL: Supported. The default VLAN of the port can not
be voice VLAN and the egress rule of the access port in the
default VLAN should be TAG.
ACCESS、TRUNK、GENERAL: Not supported.
voice
ACCESS: Not supported.
TRUNK:Supported. The default VLAN of the port should be
voice VLAN.
GENERAL:Supported. The default VLAN of the port can noe
be voice VLAN and the egress rule of the access port in the
default VLAN should be TAG.
ACCESS: Supported. The default VLAN of the port should be
voice VLAN.
TRUNK: Supported. The default VLAN of the port should be
voice VLAN and the access port permits the packets of the
voice VLAN.
GENERAL: Supported. The default VLAN of the port can noe
be voice VLAN and the egress rule of the access port in the
default VLAN should be UNTAG.
Pingtel phone
Polycom phone
3com phone
126

Advertisement

Table of Contents
loading

Table of Contents