Alarm Level From The Main Screen; Alarm Contact Settings - Zhone IMA CS-200 System Reference Manual

Alarm ports
Figure 11-3 shows the Alarm Ports Main Screen. This screen allows the crafts person to
individually set the alarm outputs (SWITCH) and the alarm inputs (SENSOR).The inputs are
received on leads through the 50-pin Amphenol connector. Please refer to Table 2-5 on page
2-8 for the pin-out descriptions. The outputs are transmitted through the RJ45 connector
labeled ALARM on the rear of the IMAC-200 chassis, along with the Sub Rate Data
connectors. Please refer to Table 2-9 on page 2-11 for a description of the output pin-outs.
The bottom highlighted line of the screen shows actions that you can perform from this screen.
To perform an action, simply press the uppercase letter on your keyboard that corresponds to
the desired action. Table 11-1 lists these actions, and Table 11-1 summarizes the port option
settings and default values. Each parameter is also described in the following paragraphs.
Alarm Ports
Figure 11-2. Alarm Level from the Main Screen
Figure 11-3.Alarm Contact Settings
Alarm port User Screens and Settings
11-3