Running Head
Test Screen
8.3
Test Screen
Pressing "t" (Test command) in the SRU port Main Screen will bring up the Test Screen
shown in Figure 8-4. From this screen, you can create test situations between SRU ports, or
between a single port and data test equipment at a remote site.
The bottom highlighted line of the Test Screen shows some actions you can perform from this
screen. To perform an action, just press the uppercase key for the desired choice. Table 8-4
lists these actions, and Table 8-5 lists the settings in the Test Screen, along with their possible
and default values. These settings are also described in the following paragraphs.
8-8
Figure 8-4.Typical SRU port Test Screen
Model No.
SRU Ports
Sub Rate Data Ports