Hsu Setting Options And Defaults - Zhone IMA CS-200 System Reference Manual

Undo Returns all settings to the last saved state.
Refresh Updates certain time-related information fields that are not automatically
updated (i.e., performance and test data).
Copy Copies the contents of the current column to the next column. Useful if you
change a lot of entries in one column and want to repeat those changes in
subsequent columns.
Test Initiates and monitors testing of all HSU Card ports. Refer to the Test section
of this chapter.
Main Returns to the System Main Screen. If changes are made to settings and not
saved, you will be prompted to save or lose changes.
Parameter
STATE stdby actv
WAN wan-1 wan-2 wan-3 wan-4 owan-1 owan-2
owan-3 owan-4
MODE dce
TS table
RATE 64k 56k
TX CLOCK int ext
Tx CLOCK PLRTY norm inv
Rx CLOCK PLRTY norm inv
DATA PLRTY norm inv
CTS perm rlocal ignor local
CTS DELAY 0 30 60 100
LOCAL LB off dte net
LB GEN MODE v.54 ft1
LB GEN off ds0
LB DET w/to on off
EER THRHD off 10e-4 10e-5 10e-6 10e-7 10e-8 10e-9
Notes:
1. The valid range displayed is from 1-24 for T1, and 1-31 for E1.
STATE
The State setting determines whether the port is active or inactive. An inactive port does not
occupy time slots on a WAN link. Set State to standby (stdby) for ports you are not using or
have not yet configured. Set it to active (actv) for ports that are ready for use. The control leads
assume the status shown in Table 9-3 for the different states.
High Speed Data Ports
Table 9-2. HSU Setting Options and Defaults
User Options Notes Default
stdby
wan-1
dce
1 table
56k
int
norm
norm
norm
perm
0
off
v.54
off
w/to
off
9-3