Dns2; Ethernet Port Settings - Panasonic KX-UT248-B Administration Manual

Phone User Interface
Reference
Configuration File Reference

DNS2

Description
Value Range
Default Value
Phone User Interface
Reference
Configuration File Reference

4.3.2 Ethernet Port Settings

This screen allows you to change the connection mode of the Ethernet ports and the VLAN settings.
Note
•
When you change the settings on this screen and click [Save], after the message "Complete" has been
displayed, the unit will restart automatically with the new settings applied. If a unit is on a call when
"Complete" has been displayed, the unit will restart after the unit returns to idle.
•
Incorrect settings may cause a network failure. In such a case, you cannot access the Web user
interface anymore. To access it again, you need to correct the speed/duplex settings or perform IP
Document Version 2012-06
Configuring the Network Settings of the Unit (Page 19)
USER_DNS1_ADDR (Page 192)
Specifies the IP address of the secondary DNS server.
Note
•
This setting is available only when [Connection Mode] is set
to [Static].
Max. 15 characters ("n.n.n.n" [n=0–255], except "0.0.0.0",
"255.255.255.255", "127.0.0.1", etc.)
Not stored.
Configuring the Network Settings of the Unit (Page 19)
USER_DNS2_ADDR (Page 192)
4.3.2 Ethernet Port Settings
Administrator Guide 81