Adjusting Projector Settings - Smart Technologies SMART Board 800i5-SMP Configuration And User's Manual

C H A P T E R 3
Using your interactive whiteboard system
N
N O T E
The Mute, Volume Up and Volume Down buttons work only if there is an audio source and
speaker system connected to the projector for the currently selected input source.

Adjusting projector settings

The remote control's Menu button enables you to access the on-screen display to adjust the projector
settings.
I
I M P O R T A N T
There are no projector menu options on the ECP. Keep your remote control in a safe place because
the ECP is not a substitute for the remote control.
Setting Use
Image Adjustment menu
Display Mode Indicates the projector's display output
(SMART Presentation,
Bright Room, Dark Room, sRGB
and User).
Brightness Adjusts projector brightness from 0 to
100.
Contrast Adjusts the difference between the
lightest and darkest parts
of the image from 0 to 100.
Frequency Adjusts the display data frequency of
the projected image from -5 to 5 to
match the frequency of your
computer's graphics card.
Tracking Synchronizes your projector's display
timing with your computer's graphics
card from 0 to 63.
H-position Moves the horizontal position of the
source video left or right from 0 to 100
(relative to the projected image).
14
Notes
The default is SMART Presentation.
The default is 50.
The default is 50.
The default is 0.
This setting applies to VGA inputs
only.
This setting applies to VGA inputs
only.
Don't adjust this setting unless you're
advised to by SMART Support.
Apply this setting only after you make
all boom adjustments.
This setting applies to VGA inputs only
and is useful in situations where the
source video is cut off.