Audio Controls - Smart Technologies SMART Board 800i5-SMP Configuration And User's Manual

A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
N
N O T E
Some of these commands are invalid with HDMI input and VGA video sources, and will return the
response "invalidcmd=[command]".
These commands inform you of the current Composite video source settings.
Command
get saturation
get tint
get sharpness
These commands control the appearance of your Composite video source. See Value-based
command methods on page 74 for setting absolute and adjustment commands.
Command
set saturation [value]
set tint [value]
set sharpness [value]

Audio controls

These commands control your projector's internal audio amplifier, which affects sound passed
through the projector to your external audio system (not included). Audio output controls aren't defined
by the video source. These settings are unavailable when the projector is in Standby mode.
These commands inform you of the current audio output settings.
Command
get volume
get mute
get volumecontrol
These commands control your projector's audio amplifier settings. See Value-based command
methods on page 74 for setting absolute and adjustment commands.
Command
set volume [value]
set mute [target]
set volumecontrol [target]
79
Response
saturation=[current saturation setting]
tint=[current tint setting]
sharpness=[current sharpness setting]
Command target range
=0 to =100
=0 to =100
=0 to =31
Response
volume=[current volume setting]
mute=[current mute setting]
volumecontrol=[current volume control setting]
Command target range
=-20 to =20
=on
=off
=on
=off
Response
saturation=[value]
tint=[value]
sharpness=[value]
Response
volume=[value]
mute=[target]
volumecontrol=[target]