Video Source Specification Values; Power State Controls - Smart Technologies SMART Board 800i5-SMP Configuration And User's Manual

A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
>set brightness-15
brightness=55

Video source specification values

You can use the source input field described in Source selection controls on next page in a command
to set an absolute value or adjustment value to a source other than the active source. You can do this
while the selected source is inactive, but the source device must be connected or you will receive an
invalid command response.
See the following examples, where both an HDMI connector and a VGA 1 input are connected:
>set input=hdmi
input=hdmi
>set brightness vga1=65
brightness vga1=65
>set brightness vga1-7
brightness vga1=58

Power state controls

These commands put the projector in and out of Standby mode and request the projector's current
power state. The projector's power state determines whether certain commands are available at that
time. These settings are available even when the projector is in Standby mode.
Command
on
off
off now
get powerstate
The following table describes the power state commands:
Command
on
off
off now
get powerstate
75
Response
powerstate=[field]
powerstate=[field]
powerstate=[field]
powerstate=[field]
Description
Turns on the projector.
Starts the shutdown process. A dialog box appears with the
message, "Press Power Button to Turn off Projector." You must send
a second Off command within 10 seconds to put the projector into
Standby mode.
Shuts down the projector immediately. You can't delay or cancel this
command.
Indicates the projector's current power state.