Figure 3-7. Remove Standoffs From Ups And External Fault Connectors - Compaq StorageWorks TM RAID Array 3000 Pedestal Storage Subsystem Hardware User's Manual

3-12 RAID Array 3000 Pedestal Storage Subsystem Hardware User's Guide
Figure 3-7 shows how to remove standoffs from the UPS and external fault
connectors.

Figure 3-7. Remove standoffs from UPS and external fault connectors

11. Align the connectors on the replacement EMU with the connector holes
on the rear panel and replace the mounting studs to secure the board (Do
not over-tighten).
12. Reconnect the two ribbon cables to the rear connectors on the EMU
board.
13. Replace the side cover on the pedestal and secure it with the TORX-
head screw on the front bezel of the pedestal.
14. Replace the door on the pedestal.
3000-49