Updating Firmware; Figure 5-3. Saved Configuration; Figure 5-4. Update Firmware Command - Compaq StorageWorks TM RAID Array 3000 Pedestal Storage Subsystem Hardware User's Manual

5-4 RAID Array 3000 Pedestal Storage Subsystem Hardware User's Guide

Updating Firmware

A Save Configuration screen with a Save to File field appears as shown in
Figure 5-3. The example in Figure 5-3 shows the file name as c:\config1.
Enter your file name in the Save to File field and click Save.

Figure 5-3. Saved configuration

CAUTION: If the systems disk is on the RA3000, firmware cannot be upgraded
with SWCC. Establish a temporary system disk on a disk drive outside the
RA3000 and proceed with these instructions or follow the alternative shown in
Section Update Firmware Using Serial Interface.
Updating Firmware Using SWCC
Start SWCC and choose SCSI or Network Connection. From the Storage
menu, select Controller, and then select Update Firmware (Figure 5-4),

Figure 5-4. Update firmware command