Upgrading Firmware On The Sdlt Drive - Compaq StorageWorks SDLT 110 Reference Manual

Table 4–1: Troubleshooting Chart
If
The amber indicator is
on
Fatal or nonfatal errors
occur for which a cause
cannot be determined
After taking the action listed in Table 4–1, power on the SDLT drive to rerun POST.

Upgrading Firmware on the SDLT Drive

The firmware on a SDLT drive can be upgraded by the following methods:
• Using TSMC
• Using UNIX scu Utility
• Using a Field Upgrade Tape
• Using a Cartridge
StorageWorks SDLT Tape Drive by Compaq Reference Guide
Then
A drive fault has
occurred.
The bus termination or
SCSI signal cable
connections might be
incorrect.
The AC main power
source grounding might
be incorrect.
Troubleshooting the SDLT Drive
Action
Try to unload the
cartridge and
re-initialize the drive by
turning the drive power
off and then on again.
The green light will
flash. If re-initializing is
successful, the lights
illuminate steadily again
and go off.
Ensure the SCSI bus is
correctly terminated.
(External drives only)
Plug the SDLT drive into
a grounded AC main
power outlet on the
same line powering the
server.
4–3