Setting Terminals (On Np Model Only); Table A.1 Cn2 Setting Terminal (On Np Model Drives Only) - Fujitsu MBA3073NC - Enterprise 73.5 GB Hard Drive Product Manual

A.1
Setting item
SCSI ID
Write protect
Setting item
Motor start mode
Force Narrow
Force Single Ended
Terminating power supply
* Setting at factory shipment
118
Downloaded from www.Manualslib.com

Setting Terminals (on NP model only)

Table A.1 CN2 setting terminal (on NP model drives only)
Pin pair
1 - 2 3 - 4 5 - 6
Open Open Open (Open)
Short Open Open (Open)
Open Short Open (Open)
Short Short Open (Open)
Open Open Short (Open)
Short Open Short (Open)
Open Short Short (Open)
Short Short Short (Open)
Open Open Open
Short Open Open
Open Short Open
Short Short Open
Open Open Short
Short Open Short
Open Short Short
Short Short Short
Pin pair
11 - 12 13 - 14
Open
Short
Open
Short
Note:
See the description of Section 5.3 for details of the setting requirements and notes.
manuals search engine
7 - 8 9 - 10
SCSI ID #0
SCSI ID #1
SCSI ID #2
SCSI ID #3
SCSI ID #4
SCSI ID #5
SCSI ID #6
SCSI ID #7
Short SCSI ID #8
Short SCSI ID #9
Short SCSI ID #10 (16-bit SCSI only)
Short SCSI ID #11 (16-bit SCSI only)
Short SCSI ID #12 (16-bit SCSI only)
Short SCSI ID #13 (16-bit SCSI only)
Short SCSI ID #14 (16-bit SCSI only)
Short SCSI ID #15 (16-bit SCSI only) (*)
Open Write operation is enabled. (*)
Short Write operation is disabled.
15 - 16 23 - 24
Started by the START/STOP command
Started by turning the power supply on (*)
Width of 16-bit bus (*)
Width of 8-bit bus
Open Follows DIFFSNS signal level on SCSI bus (*)
Short Single-Ended mode
Open Does not supply terminating resistor power to SCSI BUS
Short Supply terminating resistor power to SCSI BUS (*)
Setting contents
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(16-bit SCSI only)
(16-bit SCSI only)
Setting contents
C141-E270