Download Print this page

Figure 3.2 The Setting Terminals And Terminating - Fujitsu M2266S Technical Handbook

Hide thumbs

Advertisement

CNHI
CNH4
I o4 2
CNH3
15
I
IS
2
I
..- Power connector (CN2)
15
I
16
2
SCSI connector (CN1)
SCSI
terminating
resistor
14 13
C
N
CNI-12
16
15
CN7
n
M2266S/H
Technical Handbook
Notes:
1.
The user must not change the setting of terminals not described in this
section. Do not change factory settings for terminals not described.
2
Do not change the setting of terminals other than CN3 and CN9, and
do not connect or disconnect the SCSI terminating resistor module
when power is on.
3. You can change the CN3 or CN9 settings when power is on. The SCSI
ID setting is valid after power is turned on again or the SCSI bus is
reset.
4. To short the setting terminal, use the short plug attached when the
device is shipped from the factory.
P
13
Figure 3.2 The Setting Terminals and Terminating Resistor (M2266S)
Fujitsu America, Inc.
FS810125-01 . . . A
3-5

Advertisement

loading

This manual is also suitable for:

M2266h