5.3
Setting Terminals
The user must set the following terminals and SCSI terminating resistor before installing the
IDD in the system.
Setting terminal:
Figures 5.2 shows the setting terminal position. Figures 5.3 shows the allocation and default
settings.
Data loss
1.
The user must not change the setting of terminals not described in this
section. Do not change setting status set at factory shipment.
2.
Do not change the setting of terminals except following setting pins
during the power is turned on.
3.
To short the setting terminal, use the short plug attached when the
device is shipped from the factory.
CN1
CN2
Write protect: CN2 9-10
Figure 5.2
IDD setting terminals position
C141-E064-03EN
CAUTION
CN2
1 pin
5 - 5