Table of Contents
Advertisement
5.3
Setting Terminals
The user must set the following terminals and SCSI terminating resistor before installing the
IDD in the system.
Setting terminal:
Figures 5.2 shows the setting terminal position of SP model. Figures 5.3 shows SP models for
allocation and default settings.
1.
The user must not change the setting of terminals not described in this
section. Do not change setting status set at factory shipment.
2.
Do not change the setting of terminals except following setting pins
during the power is turned on.
3.
To short the setting terminal, use the short plug attached when the
device is shipped from the factory.
CN6
1
CN1
CN6, CN7
Write protect
MAx3xxxSP: CN7 13-14
6
Figure 5.2
MAx3xxxSP setting terminals position
C141-E035-02EN
CAUTION
15/16
CN7
1/2
5 - 5
Hide quick links:
Advertisement
Table of Contents
