Setting The Sub System Parameters (For Hp-Ux Only) - Fujitsu ETERNUS DX400 series Configuration Manual

Chapter 2 ETERNUS DX Connection Settings
2.2 OS Specific Settings
Example: When multiple ESX servers share ETERNUS DX LUNs, CM#0 Port#1 and CM#1 Port#1 must be assigned to
2.2.2

Setting the Sub System Parameters (for HP-UX only)

For HP-UX connection, clear the [Disable Load Balance] checkbox in the "Set Sub System Parameters" screen.
For HP-UX server, improper logs may be recorded unless sense response is restricted. Therefore, [Disable
Load Balance] should be disabled. (Sense response should be restricted.)
Note that changing the [Disable Load Balance] setting does not affect on non-HP-UX servers.
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-
the same reset group, even for single-path configurations.
Server#1
HBA#1
LAN switch#1
CM#0
Port#1
Affinity-Group
Copyright 2014 FUJITSU LIMITED
Server#2
HBA#1
LAN switch#2
CM#1
Port#1
15
P3AM-3972-08ENZ0