Connecting Cables - Fujitsu MBA3073NC - Enterprise 73.5 GB Hard Drive Product Manual

5.5
82
Downloaded from www.Manualslib.com

Connecting Cables

Connect the HDD and system with the following cables. See Section 4.3 for further details of the
requirements for HDD connector positions and connecting cables.
•
Power cable
•
SCSI cable
•
External operator panel cable (if required for NP model)
The general procedures and notes on connecting cables are described below. Especially, pay
attention to the inserting orientation of each cable connector.
Damage
1. Make sure that system power is off before connecting or disconnecting
cables.
2. Do not connect or disconnect cables when power is on. (except NC
model)
a) Connect power cable.
b) Connect the external operator panel (if required for NP model).
c) Connect the SCSI cable.
d) Fix the cables so that they do not touch the DE and PCAs, or so that the smooth flow of the
cooling air in the system cabinet is assured.
Damage
1. Be careful of the insertion orientations of the SCSI connectors. With the
system in which terminating resistor power is supplied via the SCSI
cable, if the power is turned on, the overcurrent protection fuse of the
terminating resistor power supplier may be blown or the cable may be
burnt if overcurrent protection is not provided.
When the recommended parts listed in Table 4.2 are used, inserting the
cables in the wrong orientation can be prevented.
2. To connect SCSI devices, be careful of the connection position of the
cable. Check that the SCSI device with the terminating resistor is the
last device connected to the cable.
manuals search engine
CAUTION
CAUTION
C141-E270