Hitachi L200 Series Instruction Manual page 120

3–48
"C" Group: Intelligent Terminal Functions
Output Function Summary Table – This table shows all ten functions for the logical
outputs (terminals [11], [12]) at a glance. Detailed descriptions of these functions,
related parameters and settings, and example wiring diagrams are in
Output Terminals" on page
Option Terminal
Code Symbol
00 RUN
01 FA1
02 FA2
03 OL
04 OD
05 AL
06 Dc
07 FBV
08 NDc
4–34.
Output Function Summary Table
Function Name
Run Signal ON
OFF
Frequency Arrival ON
Type 1 – Constant
OFF
Speed
Frequency Arrival ON
Type 2 – Over-
frequency
OFF
Overload Advance ON
Notice Signal
OFF
Output Deviation for ON
PID Control
OFF
Alarm Signal ON
OFF
Analog Input ON
Disconnect Detect
OFF
PID Second Stage ON
Output
OFF
Network Detection ON
Signal
OFF
Description
when inverter is in Run Mode
when inverter is in Stop Mode
when output to motor is at the set frequency
when output to motor is OFF, or in any accelera-
tion or deceleration ramp
when output to motor is at or above the set
frequency, even if in accel. or decel. ramps
when output to motor is OFF, or at a level below
the set frequency
when output current is more than the set thresh-
old for the overload signal
when output current is less than the set threshold
for the overload signal
when PID error is more than the set threshold for
the deviation signal
when PID error is less than the set threshold for
the deviation signal
when an alarm signal has occurred and has not
been cleared
when no alarm has occurred since the last
clearing of alarm(s)
when the [O] input value < B082 setting (signal
loss detected), or the [OI] input current < 4mA
when no signal loss is detected
Transitions to ON when the inverter is in RUN
Mode and the PID Process Variable (PV) is less
than the Feedback Low Limit (C053)
Transitions to OFF the PID Feedback Value (PV)
exceeds the PID High Limit (C052), and transi-
tions to OFF when the inverter goes from Run
Mode to Stop Mode.
when the communications watchdog timer
(period specified by C077) has timed out
when the communications watchdog timer is
satisfied by regular communications activity
"Using Intelligent