Epson Stylus PHOTO 1270 Service Manual page 98

EPSON Stylus Photo 870/1270
!
When installing the ASF assembly to FRAME, BOTTOM,
C H E C K
make sure the protrusion on the ASF fits in the
P O I N T
installation hole in FRAME, MIDDLE. (See Figure 4-32.)
!
When installing the ASF Unit, ensure the spur gear 32 in
the ASF Unit and the inner gear of the combination gear
(14, 28) in the DE Unit are meshed. (See Figure 4-32.)
!
When installing the ASF Unit, make sure the Hopper
Assembly is raised.
Stylus Photo 870
Combination Gear
14, 28
Installation Hole
Stylus Photo 1270
Combination Gear
14, 28
Installation Hole
Figure 4-32. Check Points in ASF Assembly
Disassembly And Assembly
Gear 32
Protrusion
Gear 32
Protrusion
Disassembly Procedures
!
When connecting the cables for ASF HP sensor and
C H E C K
MOTOR ASSEMBLY, PF, set them in the cable clamp in
P O I N T
the rear left part of the ASF Unit as shown in the figure
below:
Cable Clamp
Revision B
98