Epson Stylus PHOTO 1270 Service Manual page 141

EPSON Stylus Photo 870/1270
Table 6-2. Lubrication Point
Lubrication Point
1 BUSHING, 12, RIGHT
• Using a brush, apply the grease
evenly to the inside surface of the
bushing.
2 HOLDER, PULLEY, DRIVEN
3 BUSHING, 12, LEFT
• Using a brush, apply the grease to
the inside surface of the bushing.
4 BUSHING, 6
• Using a brush, apply the grease to
the inside surface of the bushing.
5 PULLEY, DRIVEN
• Apply the grease to the flat surface.
6 SHAFT, PULLEY, DRIVEN
7 COMBINATION GEAR, 12, 22.4
• Using a dispenser, apply the oil to
the entire inside circumference of
the gear.
8 COMBINATION GEAR, 14, 28
• Using a dispenser, apply the oil to
the entire inside circumference of
the gear.
9 Pole C (2 points)
10 FELT, D3.6 for COMBINATION GEAR
12, 22.4
• Wipe off any excess oil that comes
out toward the motor.
MAINTENANCE
Lubricant Type &
Refer to:
Amount
G-26 Page 142
A 3-mm wide bead
G-26 Page 142
φ
1 x 3mm (for each of
the 4 points)
G-26 Page 143
A 3-mm wide bead
G-26 Page 143
A 1-mm wide bead
G-26 Page 143
φ
1 x 1mm (2 points)
G-26 Page 143
φ
1 x 1mm
O-12 Page 143
O-12 Page 143
φ
G-26, 1 x 3mm Page 143
O-12 Page 143
Dip the felt in the oil
to soak it.
Overview
Table 6-2. Lubrication Point (continued)
Lubrication Point
11 FELT, D3.6 for COMBINATION GEAR
14, 28
• Wipe off any excess oil that comes
out toward the motor.
12 Groove on "ROLLER, PF"
Contact area for ROLLER, EJECT and
13
GROUND SPRING, EJECT
14 Contact areas for ROLLER, PF and
PAPER GUIDE, REAR
• Apply the grease while rotating the
shaft.
NOTE: Do not get the grease on the
specially coated area of
ROLLER, PF.
15 PAPER GUIDE, FRONT (3 points)
NOTE: Do not get the grease on the
rubber rollers of the Paper
Eject Roller.
Oil pad in the carriage assembly
16
• Lubricate the oil pad only when:
1) Replacing the carriage unit
2) Replacing the oil pad
• Use a dispenser to supply oil.
• After oiling to the pad, leave it for
one minute and then mount it to the
carriage unit with its oiled side
facing the CR guide shaft.
NOTE: If you sypply too much
oil, throw away the pad
and start over with a new
one.
Revision B
Lubricant Type &
Refer to:
Amount
O-12 Page 143
Dip the felt in the oil
to soak it.
G-26 Page 144
φ
1 x 5mm
G-26 Page 144
φ
1 x 2mm
G-26 Page 144
φ
1 x 1/2 of the
circumference
G-26 Page 144
φ
• 1 x 2mm
(Eject Roller side)
φ
• 1 x 10mm
(PF Roller side)
O-12
0.72 ~ 0.77cc (0.65 ~
0.69g)
141