Epson Stylus PHOTO 1270 Service Manual page 96

EPSON Stylus Photo 870/1270
10. Remove the CBS screw (3x6) and CBP (3x8) screw securing the DE
unit to FRAME, MIDDLE and FRAME, TOP, respectively. Then remove
DE unit.
CBP (3x8)
Figure 4-27. DE Unit Removal
11. Remove the harnesses from the harness clamp in the DE Unit.
C A U T I O N Be sure to remove the screw (CBP, 3x8) carefully so you do
not damage the linear encoder (SCALE, CR).
Disassembly And Assembly
SCALE, CR
CBP (3x6)
Disassembly Procedures
!
Check that all gears are assembled in the DE unit
C H E C K
correctly as shown in the figure below:
P O I N T
Combination Gear,
12, 22.4
Combination Gear,
17.19, 25.6
LEVER, PLANETARY UNIT
Figure 4-28. Parts Layout in DE Unit
!
Before assembling MOTOR ASSEMBLY, ASF to the DE
Unit, set LEVER, PLANETARY UNIT to the pump side.
(See Figure 4-28.)
!
Set TENSION BELT, PUMP, TRANSMISSION to the 17.19
gear of the Combination Gear (17.19, 25.6) before
securing the DE unit to FRAME, MIDDLE.
DE Unit
Revision B
Retaining Ring, D8.8
Felt, D3.6
Combination
Gear, 14, 28
BRACKET, MOTOR,
ASF
Combination Gear,
17.19, 25.6
TENSION BELT, PUMP,
TRANSMISSION
96