Epson Stylus PHOTO 1270 Service Manual page 106

EPSON Stylus Photo 870/1270
8. Remove the torsion spring (63.7) hung onto FRAME, TOP and LEVER,
PG.
BUSHING, PARALLELISM
ADJUSTMENT, RIGHT
TORSION SPRING, 63.7
Figure 4-49. LEVER, PG, SUB Removal
9. Remove LEVER, PG from LEVER, PG, SUB.
10. Release the hook fixing LEVER, PG, SUB to SHAFT, CR, GUIDE. Then
remove LEVER, PG, SUB and the one leaf spring (6.2x0.15x11).
11. Remove the one screw (CBS Tite Sems R2, 3x6) securing BUSHING,
PARALLELISM ADJUSTMENT, RIGHT to FRAME, TOP.
12. Rotate BUSHING, PARALLELISM ADJUSTMENT, RIGHT to align its
notch with the cutout in FRAME, TOP. Then remove the bushing.
Disassembly And Assembly
CBS Tite Sems R2
Leaf Spring
LEVER, PG, SUB
Disassembly Procedures
Notch in BUSHING,
PARALLELISM
ADJUSTMENT, RIGHT
Figure 4-50.
BUSHING, PARALLELISM ADJUSTMENT, RIGHT Removal
13. Remove SHAFT, CR, GUIDE from FRAME, TOP together with the
Carriage Unit.
14. Remove SHAFT, CR, GUIDE and the oil pad from the Carriage Unit.
!
Do not touch SCALE, CR (linear scale) with your bare
C A U T I O N
hands, because if its surface is dirty or damaged, it will
cause the carriage to operate abnormally.
!
Do not touch SCALE, PF (loop scale) with your bare
hands, because if its surface is dirty or damaged, it will
adversely affect paper feeding accuracy.
!
If you replace the Carriage Unit, perform the Platen Gap
A D J U S T M E N T
R E Q U I R E D
Adjustment.
Revision B
FRAME, TOP
106