Epson Stylus PHOTO 1270 Service Manual page 103

EPSON Stylus Photo 870/1270
!
When installing the edge guide to the left LD Roller
C H E C K
Assembly, ensure that the rib in the LD Roller Assembly
P O I N T
fits correctly into the groove in the edge guide. (See
Figure 4-41.)
!
Make sure that the right LD Roller Assembly is fixed with
the hook in FRAME, ASF; B. You can check its condition
from the back of the ASF Unit. (See Figure 4-42.)
!
Before assembling the ASF Unit, hold each compression
spring (1.961) with the hook of the spring bearing in the
Hopper Assembly. Then, after attaching the Hopper
Assembly to FRAME, ASF; B, release the springs from
the hooks through the cutouts in the back of the frame.
(See Figure 4-43.)
Groove in the Edge Guide
Rib in the LD Roller Assembly
Figure 4-41. LD Roller Assembly Installation (2)
Disassembly And Assembly
Hook in the FRAME, ASF; B
Figure 4-42. Hook Fixing the LD Roller Assembly
Figure 4-43. Holding Compression Spring with the Hooks
Disassembly Procedures
Compression
Hooks
Spring 1.961
Revision B
103