Printhead Unit Removal - Epson Stylus PHOTO 1270 Service Manual

EPSON Stylus Photo 870/1270

4.2.4 Printhead Unit Removal

1. Remove HOUSING. (Refer to Section 4.2.1.)
2. Set the PG lever to the rear.
3. Using tweezers, put the CR lock lever down to unlock the carriage.
4. Release the three hooks (A, B, C) fixing HOLDER, CABLE to the
carriage, and remove HOLDER, CABLE.
C
Figure 4-8. Printhead Removal
5. Disconnect the head FFC from the connector on the printhead.
6. Remove the FFC from the BOARD ASSEMBLY, ENCODER.
FFC
CBB Sems W2 (M2.5x6)
Figure 4-9. Encoder FFC Removal
Disassembly And Assembly
Head FFC
HOLDER, CABLE
B
A
BOARD ASSEMBLY,
ENCODER
Disassembly Procedures
7. Remove the TORSION SPRING, 28.4 hung to the carriage and
FASTENER, HEAD.
TORSION SPRING,
28.4
FASTENER, HEAD
Figure 4-10. TORSION SPRING, 28.4 Removal
8. Remove the six screws (CBP, 3x6) securing FASTENER, HEAD to the
carriage, and remove FASTENER, HEAD.
CBP (3x6)
Figure 4-11. FASTENER, HEAD Removal
9. Move the carriage to the left end of the printer manually.
10. Remove the one screw (CCB Sems W2, 2.5x6) (Refer to Figure 4-9)
securing the printhead to the carriage, and remove the printhead.
Revision B
FASTENER, HEAD
85