Epson Stylus PHOTO 2000P Service Manual page 122

EPSON Stylus PHOTO 2000P
4. Bring the carriage to the center of the printer mechanism. Then place
the thickness gauges (1.14 mm) on the front paper guide aligning
them with the right and left square cutouts in the front paper guide.
(See Figure 5-2.)
Left Edge
Front Paper Guide
Carriage Unit
Cutout
Gauge Aligning Position
PF Roller
Front Paper Guide
Figure 5-2. Placing the Thickness Gauge
To move the carriage unit, pull the timing belt with your
C H E C K
hand.
P O I N T
Be careful not to damage the CR scale (linear encoder).
ADJUSTMENT
Right Edge
(Home Position Side)
Cutout
Thickness
Gauge
• Set the gauge on the horizontal
top of the ribs.
• Bring the rib tops to the middle
of the gauge.
5. Move the carriage unit over the gauge on the right.
6. If the printhead does not touch the gauge, turn the bushing to the rear
to make the printhead touch the gauge and then, from the touching
position, bring the bushing back by one notch. On the other hand, if
the printhead already touches the gauge, turn the bushing to the front
to make the printhead touch the gauge, and then push the bushing
back by one notch.
7. Move the PG lever to the rear (+).
8. Move the carriage unit over the thickness gauge on the left.
9. Bring the PG lever to the font (0).
10. Make the adjustment as in the same manner as in step 6.
11. Bring the PG lever to the rear (+).
12. Move the carriage back over the thickness gauge on the right.
13. Move the PG lever back to the front (0).
14. Make the adjustment again on the right parallelism adjustment
bushing. If the result is good, the adjustment is completed.
15. Fix the both bushings with screws.
Adjustment
Revision A
122