Epson Stylus PHOTO 2000P Service Manual page 92

EPSON Stylus PHOTO 2000P
1. When handling CLEANER, HEAD, note the points below:
C A U T I O N
Do not touch CLEANER, HEAD with your bare hands.
Ware gloves or use tweezers.
Do not smear CLEANER, HEAD with oil or grease.
When installing CLEANER, HEAD, set the rubber side
(black side) facing to the right.
2. When replacing the Cap Assembly, do not touch its
sealing rubber part.
1. When assembling the Cap Assembly to the Ink System
C H E C K
Assembly, make sure ABSORBER, SLIDER, CAP is
P O I N T
assembled in the cap assembly. ABSORBER, SLIDER,
CAP should be set as shown in Figure 4-15 in advance.
2. Check that the ink tube is securely connected to the
connection part of the Cap Assembly. (See Figure 4-16.)
Also, make sure the tube is not bent or crushed by the
connection area. (See Figure 4-17.)
3. Check that the ink tube is placed correctly in the Ink
System. (See to Figure 4-16.) Pay special attention in
connecting the tube to the Pump Unit. Connect the tube
by strictly following the instruction given in Figure 4-18.
4. When assembling, be careful not to crush or leave any
stress on the ink tube that connects the Pump Unit and
Cap Assembly. Also,
5. After installing the Pump Unit, ensure that CLEANER,
HEAD moves back and forth with rotation of the gear.
DISASSEMBLY AND ASSEMBLY
Figure 4-15. Setting the ABSORBER, SLIDER, CAP
Pump Unit
Disassembly Procedures
About 45
°
About 60-90
Cap Assembly
Ink Tube
Figure 4-16. Ink Tube Installation (1)
Revision A
°
ABSORBER, SLIDER,
CAP
92