EPSON Stylus PHOTO 2000P
6. Remove the two screws (CBP, 3x8) securing SHIELD PLAT, PANEL to
the Panel Unit, and then remove SHIELD PLATE, PANEL.
SHIELD PLATE, PANEL
CBP (3x8)
BOARD ASSEMBLY, PANEL
Cup P-Tite (3x6)
Harness
Figure 4-7. BOARD ASSEMBLY, PANEL Removal
7. Remove the two screws (CBP, 3x8 / Cup P-Tite, 3x6) securing BOARD
ASSEMBLY PANEL to the Panel Unit.
8. Disconnect the harness from BOARD ASSEMBLY, PANEL.
C A U T I O N
When removing the Panel Unit, watch out for the stacker
assembly. Since the stacker assembly is attached to the
Panel Unit and HOUSING, PANEL, LEFT, if you remove the
Panel Unit, the stacker assembly will also come off.
DISASSEMBLY AND ASSEMBLY
CBP (3x8)
CBP (3x8)
Disassembly Procedures
Revision A
86