Epson Stylus PHOTO 2000P Service Manual page 100

EPSON Stylus PHOTO 2000P
When installing the ASF assembly to FRAME, BOTTOM,
C H E C K
make sure the protrusion on the ASF fits in the
P O I N T
installation hole in FRAME, MIDDLE. (See Figure 4-32.)
When installing the ASF Unit, ensure the spur gear 32 in
the ASF Unit and the inner gear of the combination gear
(14, 28) in the DE Unit are meshed. (See Figure 4-32.)
When installing the ASF Unit, make sure the Hopper
Assembly is raised.
Combination Gear
14, 28
Installation Hole
Figure 4-32. Check Points in ASF Assembly
DISASSEMBLY AND ASSEMBLY
C H E C K
P O I N T
Gear 32
Protrusion
Disassembly Procedures
When connecting the cables for ASF HP sensor and
MOTOR ASSEMBLY, PF, set them in the cable clamp in
the rear left part of the ASF Unit as shown in the figure
below:
Cable Clamp
Revision A
100