De Unit Removal - Epson Stylus PHOTO 2000P Service Manual

EPSON Stylus PHOTO 2000P

4.2.9 DE Unit Removal

1. Remove HOUSING (Refer to Section 4.2.2.)
2. Remove MOTOR ASSEMBLY, CR. (See Section 4.2.7.)
3. Remove the Ink Unit. (Refer to Section 4.2.6.)
4. Remove the two screws (CBS, 3x6) securing SHEET, PROTECTION
INK to FRAME, BOTTOM, and then remove the sheet.
FRAME, TOP
SHEET, PROTECTION, INK
FRAME, BOTTOM
Figure 4-23. SHEET, PROTECTION, INK Removal
DISASSEMBLY AND ASSEMBLY
CBS (3x6)
Disassembly Procedures
5. Remove MOTOR, CR. (Refer to Section 4.2.7.)
6. Loosen the one screw (CBS, 3x6) securing the LEVER ASSEMBLY,
COMBINATION GEAR to FRAME, MIDDLE.
7. Remove the tension sprig (7.37) hung to FRAME MIDDLE and LEVER
ASSEMBLY, COMBINATION GEAR, and then remove TENSION BELT,
PUMP, TRANSMISSION from the combination gear (12, 22.92).
TENSION SPRING, 7.37
LEVER ASSEMBLY,
COMBINATION GEAR
FRAME, MIDDLE
CBS (3x6)
Figure 4-24. TENSION BELT, PUMP, TRANSMISSION Removal
Revision A
COMBINATION GEAR,
12, 22.92
TENSION BELT, PUMP,
TRANSMISSION
96