Epson Stylus PHOTO 2000P Service Manual page 88

EPSON Stylus PHOTO 2000P
A D J U S T M E N T
When you replace the Printhead Unit, perform the
R E Q U I R E D
following adjustments:
1. Initial ink charge (Refer to Chapter 5/Section 5.1.1.)
2. Head Voltage ID Input (Refer to Chapter 5/Section
5.1.2.)
3. Head Angular Adjustment (Refer to Chapter 5/Section
5.1.3.)
4. Bi-D Adjustment (Chapter 5 /Section 5.1.4.)
When installing FASTENER, HEAD, first fasten the two
C H E C K
screws (CBP, 3x6) securing FASTENER, HEAD and the
P O I N T
CBB Sems W2 (M2.5x6) temporarily, and then attach the
torsion spring. After that, fasten the screws tightly.
When installing FASTENER, HEAD to the Carriage Unit,
fasten the screws in the following order:
1) CBP (3x6) on the right
2) CBP (3x6) on the left
3) CBB Sems W2 (M2.5x6)
DISASSEMBLY AND ASSEMBLY Disassembly Procedures
Revision A
88