Using The Adjustment Program; About The Adjustment Program; How To Install The Program; How To Uninstall The Program - Epson Stylus PHOTO 2000P Service Manual

EPSON Stylus PHOTO 2000P

5.2.3 Using the Adjustment Program

Each product has its unique information on the main board to maintain its
print ability and quality at an optimum level. For this reason, you need to
write the correct information of the printer mechanism to the main board
using the adjustment program whenever you replace either printer
mechanism or main board.

5.2.3.1 About the Adjustment Program

The basic adjustment items you can perform using this program are as
shown below:
Table 5-4. Adjustments Using the Program
No. Main Items
1 Adjustment
2 Maintenance
3 Recovery for clogged nozzle
4 Print A4 pattern

5.2.3.2 How to Install the Program

Before installing the program, note the points below:
Use Windows 95 or 98.
Use LPT 1 only as the printer port. (Use a USB interface cable only
when performing USB ID check/input.)
ADJUSTMENT
Adjustment items
Head voltage ID input
Head angular adjsutment
Bi-Directional adjustment
USB ID check/input
Head cleaning
Initial ink charge
Protection counter check/clear
CSIC information
Recovery for clogged nozzle
Print A4 pattern
Adjustment
Install the program in the order listed below:
1. Insert "Disk1" to the 3.5" floppy disk drive of your computer, and then
execute "Setup.exe".
2. As the wizard askes, insert "Disk2", and the installation is done.
3. Click Stylus Photo 2000P.exe icon created in Program Files \
Adjustment Program \ Stylus Photo 2000P folder to execute the
program.
While you are running the service program on Windows
C A U T I O N
95/98, you can not use EPSON Status Monitor. Therefore,
close the printer window on the task bar before you start
the program.
If you can not start the program because LPT1 is set to
ECP Printer Port, turn it off in the order below:
1. Delete all printer drivers.
2. Access Control Panel>System>Device Manager>Ports
and delete ECP Printer Port.)
3. Reboot the computer.
If you leave the printer in a non-printing status for 5
minutes or more, the carriage automatically returns to
home position. In this case, you need to reboot the
computer to run the program.
Do not change the setting for Font size in Display settings.
Be sure to connect a parallel interface cable to the printer
before you start the program. Otherwise, the program
freezes.
Do not send any command to the printer during a check
pattern print.
While the service program is running, if the printer is
turned off or the interface cable is disconnected, you need
to launch the program again.

5.2.3.3 How to Uninstall the Program

Access Control Panel> Add/Remove Programs and uninstall the program.
Revision A
125