Overview; Precaution For Disassembling The Printer - Epson Stylus PHOTO 2000P Service Manual

EPSON Stylus PHOTO 2000P

4.1 Overview

This chapter describes procedures for disassembling the main
components of the EPSON Stylus PHOTO 2000P. Unless otherwise
specified, disassembly units or components can be reassembled by
reversing the disassembly procedure. Therefore, no assembly procedures
are included in this chapter. Precautions for any disassembly or assembly
procedure are described under the heading "CAUTION" and "CHECK
POINT". Any adjustments required after disassembling the units are
described under the heading "REQUIRED ADJUSTMENT".
DISASSEMBLY AND ASSEMBLY

4.1.1 Precaution for Disassembling the Printer

See the precautions given under the heading "WARNING" and
"CAUTION" in this section when disassembling or assembling EPSON
Stylus PHOTO 2000P.
Disconnect the power cable before disassembling or
W A R N I N G
assembling the printer.
Wear protective goggles to protect your eyes from ink. If
ink gets in your eye, flush the eye with fresh water and
see a doctor immediately.
If ink comes into contact with your skin, wash it off with
soap and water. If irritation occurs, contact a physician.
A lithium battery is installed on the main board of this
printer. Be sure to observe the following instructions
when serving the battery:
1. Keep the battery away from any metal or other
batteries so that electrodes of the opposite polarity
do not come in contact with each other.
2. Do not heat the battery or put it near fire.
3. Do not solder on any part of the battery. (Doing so
may result in leakage of electrolyte from the battery,
burning or explosion. The leakage may affect other
devices close to the battery.)
4. Do not charge the battery. (An explosion may be
generated inside the battery, and cause burning or
explosion.)
5. Do not dismantle the battery. (The gas inside the
battery may hurt your throat. Leakage, burning or
explosion may also be resulted.)
6. Do not install the battery in the wrong direction.
(This may cause burning or explosion.)
Danger of explosion if the battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacture. Dispose the used
batteries according to government's law and
regulations.
Overview
Revision A
76