Removing The Cr Assembly - Epson Stylus COLOR 760 Service Manual

EPSON Stylus COLOR 760

4.2.4.6 Removing the CR Assembly

1. Remove the Top Housing. (Refer to Section 4.2.1)
2) Remove the Tension Spring 1.494 fixing the CR Encoder Slit Plate to the
protrusion on the left side of the Top Frame and remove the CR Encoder
Slit Plate carefully from the CR unit.
Tension Spring 1.494
Figure 4-35. Remove the Tension Spring 1.491& CR Encoder Slit
3) Loosen the Timing Belt by pushing the Driven Pulley Holder and remove
the Timing Belt from the pinion gear of the CR motor. Refer to Figure 4-18.
4) Take the Compression Spring 23.52 out of the Driven Pulley Holder with
tweezers. Refer to Figure 4-36.
Disassembly and Assembly
CR Encoder Slit Plate
Disassembly Procedures
Compression Spring 23.52
Figure 4-36. Taking out Compression Spring 23.52
5) Slide the Driven Pulley Holder to the right side and remove it to forward.
6) Remove the Driven Pulley from the Driven Pulley Holder with the timing
belt. Refer to Figure 4-37.
Driven Pulley Holder
Figure 4-37. Removing the Driven Pulley
Revision C
Driven Pulley Holder
Driven Pulley
98