Fault Messages Will Not Clear - Xerox WorkCentre 5050 Quick Reference Manual

Jobs scan but do not print
Output does not reflect the selections made on the
Touch Screen

Fault Messages will not clear

CAUTION: Wait approximately 20 seconds before turning the machine back
ON. Any incomplete jobs in the queue will be lost.
CAUTION: Use only the ON/OFF switch to reboot your machine. Damage may
occur to your machine if power is removed by other means.
Page 11-10
Some jobs require image processing before printing. This may take as long as 2
seconds per page.
Check the Job Status queue to determine if a job is processing. There may be a
job in the queue with a status of paused. Delete this job if it remains in the state
over 3 minutes.
This may possibly be a result of an incorrect feature combination. The software
may need to be reset. Contact your System Administrator.
Press Clear All between jobs.
If a Save button displays on the touch screen, ensure Save is selected after
each selection.
There may be occasions when a fault is cleared but the message will not clear.
Reboot your machine by powering OFF and ON using the ON/OFF switch at the
side of the machine.
Quick Reference Guide