Xerox WorkCentre 5050 Quick Reference Manual page 81

Dialing characters are special characters used for entering fax numbers. They are
Dialing
entered as part of the telephone number:
Characters
Wait for Dial Tone [=]
Pulse to Tone Switch
Readability Digits
This feature allows users to create a single fax recipient by adding two or more fax
Chain Dialing
numbers together. For example, an area code may be stored separately to the
telephone number, Chain Dialing combines these entries into a single fax number.
Chain Dialing is accessed from the Send List.
Quick Reference Guide
Starts a sequence of DTMF (Dual Tone Multi-frequency)
Begin DTMF [*]
characters.
Ends a sequence of DTMF (Dual Tone Multi-frequency)
End DTMF [#]
characters.
Suspends dialing until an expected network dial tone is
detected. Can also be used to detect a specific tone when
accessing an outside line or other services.
Used to switch from pulse dialing to DTMF (tone or one-
touch) dialing. After switching from pulse to tone, you cannot
[:]
switch back to the original mode during the fax procedure.
Identifies the different components of the fax number, for
[( )] example the dialing code (1234) 56789.
Start Mailbox
Pauses regular fax dialing and starts DTMF (Dual Tone Multi-
Signalling [!] frequency) procedure for the fax mailbox.
Gives the machine time to switch from an inside line to an
outside line during automatic dialing. For additional pause
Pause [,]
time, add multiple pauses. For charge code numbers, enter a
pause after the fax number but before the charge code
number.
Protects confidential information, For example, if a special
charge code or credit card number is required for a call. The /
Private Data
character should be selected before and after entering
Delimiter [/]
confidential numbers. The numbers and characters entered
between this character will appear as asterisks (*).
Used to select Line 1 to dial the number. Selecting this
Line Selection
character temporarily overwrites the fax settings and is for
Identifier [<1>]
the current job only.
Used to select Line 2 (if installed) to dial the number. If a
Line Selection
second line is not installed then this option will not be
Identifier [<2>]
available. Selecting this character temporarily overwrites the
fax settings and is for the current job only.
Page 5-5