Usb Menu; Usb 01 - Mtc -> Nuendo; Usb 02 - Full Position -> Nuendo; Usb 03 - Nuendo Track Arming - Steinberg Nuendo SyncStation Operation Manual

USB menu

This menu deals with the USB connection to the Nuendo
host computer and the MIDI communication between the
SyncStation and Nuendo.
USB 01 - MTC -> Nuendo
USB 01-MTC -> Nuendo
>On >Off
This determines if MTC is transmitted to Nuendo via USB.
If this is set to Off, Nuendo cannot start playback because
the SyncStation will not transmit incoming timecode.
USB 02 - Full Position -> Nuendo
USB 02-Full Position -> Nuendo
>Off >MMC Full >Full on change >Locate
This determines the usage of full-frame MTC messages
going to Nuendo. Just as with the MIDI Out setting, the
"Full on change" setting will work for most conditions, but
the others are available for certain circumstances.
>Off
No full-frame messages will be sent.
>MMC Full
Constant full-frame messages will be sent.
>Full on change
Default sends full-frames only when position changes and
not during play. Using this option is recommended since it
allows you to avoid generating too much MIDI traffic.
>Locate
MMC locate commands will be sent.

USB 03 - Nuendo Track Arming

USB 03-Nuendo Track Arming
>RS422-Out >MIDI Out
This setting is independent of the MIDI and RS422 track
arming settings. Track arming buttons on the SyncStation
9-Pin device panel will be routed according to this setting.
Also, record commands sent by Nuendo's transport when
sync is enabled will be routed to the same destination.
This can be used to perform remote layback on any con-
nected device.
>RS422-Out
All record and track arming commands will be sent to the
connected 9-Pin device.
>MIDI Out
All record and track arming commands will be sent to the
MIDI output.
Changing the USB track arming in Nuendo
You can change Nuendo's track arming by selecting a
value from the Nuendo pop-up menu in the "Track Record
Arming Routing¨ section in the SyncStation Settings pop-
up window.
Setting the Nuendo track arming to MIDI Out.

USB 04 - Nuendo MIDI ID

USB 04-Nuendo MIDI ID
>0 >1 >2 >3 >4 >5 >6 >7 >8 >All(7f)
Sets the MMC ID number for Nuendo for receiving MMC
commands from the MIDI input.
Setting the USB MIDI device ID in Nuendo
The MIDI ID, MTC and Full Position settings can be made
in the SyncStation Settings pop-up window from the
SyncStation USB section.
Choosing a MIDI ID for Nuendo.
35
Menu Reference