Preliminary On-Site Checkout; Checking Interface Cables - Canon ColorPASS-Z20e Service Manual

1.4 Preliminary on-site Checkout

Your goal in the preliminary on-site checkout is to eliminate obvious problems such as
loose or missing cables and connectors, or loosely seated printed circuit boards.

1.4.1 Checking Interface Cables

Before you remove the top panel of the ColorPASS to check internal components make
sure that:
• All interface cables to the system are plugged into the proper connectors on the back
panel of the ColorPASS (see F05-104-01).
• The power cable is plugged into the wall supply.
• The power switch on the side panel of the ColorPASS is powered on.
Power switch
Power connector
Mouse connector(not used)
Keyboard connector(not used)
If all the connectors are properly in place and the power is on, proceed to the next stage of
troubleshooting.
COPYRIGHT© 2000 CANON INC.
Side panel
USB connectors(not used)
Serial connector(not used)
Parallel connector(not used)
Serial connector(not used)
F05-104-01 Back panel of ColorPASS
2000 2000 2000 ColorPASS-Z40e/Z20e REV.0 AUG. 2000
CHAPTER 5 TROUBLESHOOTING
Back panel
SCSI connector(CD-ROM)
Copier interface connector
Parallel connector(not used)
Ethernet RJ-45 connector
5-5