To Check Motherboard Dimm Connections - Canon ColorPASS-Z20e Service Manual

4.2 To Check Motherboard DIMM Connections

1. Check that all DIMMs are locked. If any DIMMs have come loose, release and reseat
them.
DIMMs (dual in-line memory modules) installed on the ColorPASS motherboard are
held in place by levers at each end.
2. To release a DIMM, push outward on the levers on each side of the DIMM.
3. Slide the DIMM straight out of the socket.
4. To replace a DIMM, gently slide the DIMM straight into the socket until the levers at
each side lock into place.
Make sure that the levers close securely around the ends of the DIMM and that each
DIMM is fully seated in its socket.
If you removed the DIMMs completely, note that DIMMs fit the socket only one way.
The notches on the bottom of the DIMM should line up with the notches in the socket.
COPYRIGHT© 2000 CANON INC.
F04-402-01 Releasing the DIMM levers
2000 2000 2000 ColorPASS-Z40e/Z20e REV.0 AUG. 2000
CHAPTER 4 DISASSEMBLY/ASSEMBLY
4-9