Motherboard Jumpers - Canon ColorPASS-Z20e Service Manual

5.7.5 Motherboard jumpers

The following section describes the locations and settings for the jumpers on the
motherboard.
The jumpers in the table below show the current shipping configuration.
Memo
Jumper Jumper area
(shipping configuration)
JP1
1
2
3
JP2
1
2
3
JP10
1 2
JP11
1 2
JP12
1 2
JP13
1 2
COPYRIGHT© 2000 CANON INC.
Description
• Bus speed settings.
• Jumper installed on pins 1 and 2.
• Clear CMOS and reset password.
• Jumper installed on pins 1 and 2 during normal opera-
tion. To reset the CMOS to the BIOS defaults, move
the jumper to pins 2 and 3, reboot, and then replace
jumper to pins 1 and 2.
• CPU speed settings.
• Jumper installed on pins 1 and 2. This setting should
not be changed.
• CPU speed settings.
• Jumper installed on pins 1 and 2. This setting should
not be changed.
• CPU speed settings.
• Jumper installed on pin 1. This setting should not be
changed.
• CPU speed settings.
• Jumper installed on pin 1. This setting should not be
changed.
T04-507-01
2000 2000 2000 ColorPASS-Z40e/Z20e REV.0 AUG. 2000
CHAPTER 4 DISASSEMBLY/ASSEMBLY
4-27