Restoring Colorpass Functionality After Service; To Reassemble The Colorpass - Canon ColorPASS-Z20e Service Manual

CHAPTER 4 DISASSEMBLY/ASSEMBLY

4.3 Restoring ColorPASS Functionality After Service

4.3.1 To Reassemble the ColorPASS

1. Reseat all boards, cables, connectors, and other parts loosened or removed during in-
spection or service.
2. Connect the UIB cable connector to the connector on operation panel board on the top
panel.
3. Install the access panel onto the ColorPASS (see F04-403-01).
Be careful not to damage any ribbon cables; if necessary, fold the ribbon cables inside
the tray before replacing the access panel.
4. Insert the three hooks on the back edge of the top panel into the three slots at the back of
the tray.
5. Press the two clips at the front of the top panel into the two slots at the front of the tray.
6. Attach the screw beneach the front edge of the ColorPASS.
Hooks
Access panel
Do not leave the ColorPASS top and access panel off after servicing. An
airflow channel is created by the access panel and the fan. Leaving the
Memo
ColorPASS open could reduce the operational life expectancy of internal
ColorPASS components.
4-10
F04-403-01 Replacing the top panel
COPYRIGHT© 2000 CANON INC. 2000 2000 2000 ColorPASS-Z40e/Z20e REV.0 AUG. 2000
Clips