Canon ColorPASS-Z20e Service Manual page 6

INTRODUCTION
Terminology and conventions
The term "ColorPASS" is used throughout this manual to refer to the ColorPASS-Z40e/
Z20e and PS-NX40W/20W.
The term "ColorPASS" is used in this manual to refer to the ColorPASS-Z40 Color
Server.
The term "Network administrator" refers to the person responsible for maintaining the
network at the customer site.
The term "Control Panel" refers to the area on the top of the ColorPASS including the
green/red activity light, the display window (LCD-liquid crystal display), and the buttons on
the sides of the display window.
The term "System software" refers to the software installed on the ColorPASS hard disk
drive.
References to other ColorPASS manuals, such as the Configuration Guide, are displayed
in italics.
Precautions
Always observe the following general precautions when installing and servicing the
ColorPASS:
1. Never alter an existing network without permission.
The ColorPASS will probably be connected to an existing Local Area Network (LAN)
based on Ethernet or Token Ring hardware. The network is the link between the
customer's computer, existing laser printers, and other prepress equipment. Never dis-
turb the LAN by breaking or making a network connection, altering termination, install-
ing or removing networking hardware or software, or shutting down networked devices
without the knowledge and express permission of the system or network administrator
or the shop supervisor.
2. Never enter an IP address in ColorPASS Network Setup.
Only the network administrator should enter an IP address on a network device.
Assigning the ColorPASS an incorrect IP address may cause unpredictable errors on any
or all devices connected to the network.
3. Always disconnect power before openig the ColorPASS.
4. Handle the ColorPASS Control Panel display window with care.
The ColorPASS display window is made of glass. If the glass breaks and the liquid crys-
tal inside leaks out, avoid contact with it. If you do come in contact with the liquid crys-
tal, wash it off with soap and water immediately.
5. Avoid pressing the surface of the display window.
Applying pressure to the display window will cause it to change color.
6. Use a soft cloth moistened with isopropyl or ethyl alcohol to clean the surface of the
ColorPASS display window.
Other solvents, such as water, may damage the polarizer on the display window.
7. Use care when handling parts of the ColorPASS as some edges on the unit may be
sharp.
For example, be careful when:
• Plugging in cables at the back of the unit
• Using the power switch to power on/off the unit
i v
COPYRIGHT© 2000 CANON INC. 2000 2000 2000 ColorPASS-Z40e/Z20e REV.0 AUG. 2000