Canon ColorPASS-Z20e Service Manual page 71

a. To Replace a DIMM
1. To release a DIMM, push outward on the levers on each side of the DIMM (see F04-
507-02.)
Lever
2. Slide the DIMM straight out of the socket.
3. To replace a DIMM, slide it straight into the socket until the levers on each side lock
into place.
Make sure that the levers close securely around the ends of the DIMM and that each
DIMM is fully seated in its socket.
DIMMs fit the socket only one way. The two notches on the bottom of each
DIMM should line up with the notches in the socket.
Memo
4. Reassemble the ColorPASS and verify its functionality (see "Restoring ColorPASS
functionality after service" on page 4-10).
COPYRIGHT© 2000 CANON INC.
DIMM
F04-507-02 Releasing a DIMM
2000 2000 2000 ColorPASS-Z40e/Z20e REV.0 AUG. 2000
CHAPTER 4 DISASSEMBLY/ASSEMBLY
Socket notches
Lever
4-23