To Replace The Hdd - Canon ColorPASS-Z20e Service Manual

CHAPTER 4 DISASSEMBLY/ASSEMBLY

5.10.2 To Replace the Hdd

1. If you are installing a new HDD, unpack the drive.
Do not unscrew the six screws on the rounded side of the HDD. Loosening
these HDD screws will break the seal and void the HDD warranty.
Do not touch the HDD with magnetic objects (such as magnetic screwdriv-
ers) and avoid placing items such as credit cards and employee ID cards
that are sensitive to magnets near the HDD.
2. Insert the HDD in the tray and align the mounting holes on the HDD with the four holes
on the side of the tray. Secure the HDD with the 4 screws.
Make sure the IDE setting for the HDD is set to master.
3. Connect the HDD cable to its connector on the HDD.
4. Connect the power supply cable to its connector on the HDD.
5. Attach the ColorPASS to the copier.
6. Reassemble the ColorPASS (see "Restoring ColorPASS functionality after service" on
page 4-10) and re-establish the connections at the back of the ColorPASS.
7. If you replaced the HDD with a new drive, install ColorPASS system software (see
"ColorPASS system software service" on page 4-43).
4-36
COPYRIGHT© 2000 CANON INC. 2000 2000 2000 ColorPASS-Z40e/Z20e REV.0 AUG. 2000